Testosterone Enanthate 250mg/ml

Testosterone Enanthate 250mg/ml

Contact : Mr.Thyen------------------------------- Email us at zhangyinglong@ycphar.com Whatsapp : +86 180 3817 6818

Product Details

Testosterone Enanthate 250mg/ml

Contact : Mr.Thyen   

Email us at zhangyinglong@ycphar.com   

Whatsapp : +86 180 3817 6818


Substance Testosterone Enanthate Injectable Steroids Test E / Test Enanthate 250

Testostone Enanthate Specification:

Test E Powder Assey: 99.31%

Test E Loss on drying: 0.18%

Test E Specific optical rotation: +79.3

Test E Melting point: 34~36C

Test E Free heptanoic acid: 34~36C

Test E Standard: EP 5

Besides Test E powder, we also provide liquid form, Deca Durabolin 300mg/ml 250mg/ml 600mg/ml.

Cook recipes: such as 100ml(250mg/ml), 25g Testostone Enanthate powder, 2mL BA (2%), 10mL BB (10%), 69.25mL Oil

Add :BB=benzyl benzoate BA=benzyl alcohol EO=ethyl oleate Oil=grapeseed oil or MCT)


Testostone Enanthate Dosage

General dosage would be 250mg to 750mg a week.

Attention: The level is quite sufficient, and should provide the user a rapid gain of strength and body weight. Above this level estrogenic side effects will no doubt become much more pronounced, possibly out weighing any new muscle gained.


How to make Test E 250 Oil?
Step 1: Put TEST E powder into the beaker
Step 2: Put BA into the beaker
Step 3: Put BB into the beaker
Step 4: Put the beaker on the heater, temperature is about 80 C. Use the glass rod to stir the liquid until the powder dissolves into the liquid totally, then it will be transparent yellow liquid
Step 5: Get the beaker down from the heater, wait until the transparent yellow liquid is cool
Step 6: Put the EO into the beaker, Use the glass rod to stir the liquid until it is transparent yellow liquid again.
Step 7: Filter the liquid with a sterile filter or a filtering machine


How to prevent How to prevent Test E pain before inject?

1. Dilute compound with sterile cutting oil to get mg/ml at< =200 for long esters and <=100 for short esters.
2. Don't bother with b-12, its water based-absorbed so quickly it will have little to no impact.
3. Gently warm the oil to improve viscosity. You could put the vial in the bathroom sink and let hot water run over the vial for 2 minutes, and shake well. This will lower the oils viscosity also making it easier it pull into the syringe.
4. Inject very slowly to reduce muscle fascia displacement, take 30 seconds per ml. Use a 25g pin to inject so it forces you to move slowly.
5. Add 20% Benzyl Benzoate by volume to propionate and phenylpropionate esetrs.
6. Use 23g needle to prevent high output pressure from smaller needles.
7. Inject frequently w/less volume, <3ml for large muscles and< 2ml for smaller muscles.
8. Ensure that the injection is deep intra-muscular and fully through any sub cutaneous fat
9. You can also add: 100mg Benadryl one hour prior to injection; 800mg ibuprofen one hour prior to injection.


Single Steroid Oil:

Product name


Test enanthate




Test propionate



Test cypionate


Sustanon 250











Trenbolone Acetate




Steroid hormone products: